Command Sequences for Setting Up Nodes
The "dspnode" screen displayed at the "shlf3igx" node shows that it is connected to the BPX switch
via AIT trunk 8.
shlf3IGX
Trunk
8
Last Command: dspnode
Next Command:
Command Sequences for Setting Up Nodes
Follow the illustrated command sequences to perform these node-related tasks:
•
•
•
•
•
Figure 17-1 Setting Up Nodes
Log on to
a node
Figure 17-2 Viewing the Node Configuration
Log on to
a node
Cisco BPX 8600 Series Installation and Configuration
17-4
TN
edgar
BPX Switching Shelf Information
Name
Type
hubone
BPX
Set up a node. See in Figure 17-1
View information about the presence of the cards and system power. See Figure 17-2.
Configure an interface for a control terminal that is connected to the node. See Figure 17-3.
Remove a node from a network. See Figure 17-4.
Add an interface shelf. See Figure 17-5.
Local
Local or
CNFNAME CNFTMZN
remote?
Remote
VT
Local
Local or
remote?
Remote
VT
IGX 8
9.3 June 20 2000 09:24 PDT
Alarm
MAJ
ADDYRED
DSPYRED ADDALMSLOT
DSPCDS
DSPCD
DSPPWR
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Chapter 17
Initial BPX 8600 Node Configuration
Yes
Another
node?
No
Yes
Another
node?
attached devices
No
View node
configuration
Configure