Sct Commands; Configuring The Bxm Card's Qbin - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 23 Configuring BXM Virtual Switch Interfaces
dspvsiif <slot.port.vtrk>
dspvsiif 1.1
dspvsiif 1.1.1
To change some of the template's qbin parameters, use the cnfqbin command. The qbin is now "user
configured" as opposed to "template configured".
To view this information, use the command dspqbin.

SCT Commands

dspsct
Use the dspsct command to display the service class template number assigned to an interface. The
command has three levels of operation:
dspqbint
Displays the qbin templates
cnfqbin
Configures the qbin. You can answer yes when prompted and
the command will use the card qbin values from the qbin templates.
dspqbin
Displays qbin parameters currently configured for the virtual interface.
dspcd
Displays the card configuration.

Configuring the BXM Card's Qbin

When you activate an interface by using an uptrk or upport command, a default service template
(MPLS1) is automatically assigned to that interface. The corresponding qbin templates are
simultaneously set up in the BXM's data structure for that interface. This service template has an
indentifier of "1".
To change the service template assigned to an interface, use the cnfvsiif command. You can do this only
when there are no active VSI connections on the BXM.
To display the assigned templates, use the dspvsiif command.
Each template table row includes an entry that defines the qbin to be used for that class of service (see
Figure 23-10).
This mapping defines a relationship between the template and the interface qbin's configuration.
A qbin template defines a default configuration for the set of qbins for the logical interface. When a
template assignment is made to an interface, the corresponding default qbin configuration becomes the
interface's qbin configuration.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
dspsct
With no arguments lists all the service templates resident in the node.
dspsct <tmplt_id>
Lists all the Service Classes in the template
dspsct <tmplt_id>
Service Classes lists all the parameters of that Service Class.
Cisco BPX 8600 Series Installation and Configuration
VSI Configuration Procedures
23-7