Replacing A Line Module; Figure 30-1 Unlatching The Air Intake Grille - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 30 Replacing Parts
Step 6 Replace the air intake grille by swinging it up and pressing in at the top until the latch snaps into place.

Figure 30-1 Unlatching the Air Intake Grille

Replacing a Line Module

The configuration of the back card may be slightly different depending on whether it is a single card or
redundant card configuration. A standby card in a redundant card configuration may be removed
without disrupting system operation even if it is a BCC. Removing a single card, however, will cause a
system outage.
Caution Removing an active, single back card disrupts service on the node.
To remove a line module:
Check the status of the card using the dspcd or dspcds command. It should be failed or standby or
Step 1
replacement will affect operation of the node.
If an active card needs to be replaced, "down" it first with the dncd command. Removing an active card
Step 2
affects operation only slightly if there is a standby card.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Power
supply
Latch
Access
hole
Cisco BPX 8600 Series Installation and Configuration
Replacing a Line Module
Released
air intake
grill
30-3