Cisco BPX-BXM-155-8DX Installation And Configuration Manual page 418

Command Line Interface Examples
pubsbpx1
TRK
1.1
2.1
2.4
Last Command: dsptrks
Next Command:
An example of the upln command for UNI port access on a BXM card:
pubsbpx1
Line
2.2
2.3
Last Command: upln 2.2
256 PVCs allocated. Use 'cnfrsrc' to configure PVCs
Next Command:
Note The initial command to up a trunk (uptrk) or to up a line (upln) on the BXM card
configures all the ports of the card to be either trunks or lines (UNI port access). After
using the upln command at each port, use the upport command to activate a port for UNI
access.
An example of the cnfln command:
Cisco BPX 8600 Series Installation and Configuration
24-6
TN silves
Type Current Line Alarm Status
T3 Clear - OK
OC-3 Clear - OK
OC-3 Clear - OK
TN StrataCom
Type Current Line Alarm Status
OC-3 Clear - OK
OC-3 Clear - OK
Chapter 24
BPX 8620 9.3 March 2 2000 13:45 PDT
BPX 8620 9.3 March 2 2000 13:54 PDT
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Configuring BXM Virtual Circuits
Other End
-
VSI(VSI)
-