Preliminary Procedure; Figure 8-1 Location Of Dc Power Entry Module(S), Cabinet Rear View - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Installing a BPX Switch in a Cisco Cabinet
Figure 8-1
Line
modules

Preliminary Procedure:

Follow these steps to install either an AC- or DC-powered BPX switch shelf, referring to Figure 8-2
and Figure 8-3 and to either Figure 8-4 for DC powered systems or Figure 8-5 for AC powered systems:
Step 1 With one person on each side of the BPX shelf, lift the BPX shelf and rest it on the temporary space bar
and temporary support brackets (see Figure 8-2).
Step 2 Slide the BPX switch shelf into the cabinet over the temporary support bar and brackets and into place
over the flanges of the brackets previously attached to the rear rails of the cabinet.
Locate the rear support brackets (P/N 215960-00B and 215960-01B) in the miscellaneous parts kit.
Step 3
Cisco BPX 8600 Series Installation and Configuration
8-2
Location of DC Power Entry Module(s), Cabinet Rear View
Redundant DC
power module (B)
Chapter 8 Installation with Cisco Cabinets including 7000 Series Routers
Primary DC
power module (A)
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001