Auto-Dial To Customer Service; Figure 15-5 Dial-Modem Cabling For Auto Answer (Dial-In To Bpx) - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 15 Connecting Temporary Terminal and Attaching Peripherals

Figure 15-5 Dial-Modem Cabling for Auto Answer (Dial-In to BPX)

FG
TXD
RXD
RTS
CTS
DSR
DTR
SG
Legend
FG
TXD - Transmit Data
RXD - Receive Data
RTS - Request To Send
CTS - Clear To Send
DSR - Data Set Ready
DTR - Data Terminal Ready
CD
SG

Auto-Dial to Customer Service

This setup procedure enables your BPX to dial up Cisco Customer Service.
Step 1 Using the cnfterm command, set the BPX AUXILIARY port speed to 9600 bps.
Enable XON/XOFF flow control.
Using the cnftermfunc command, select option 7, "Autodial Modem"
Step 2
Enter the customer service-designated Network ID and the customer service modem phone number.
Attach a 9600 bps terminal to the modem by using a straight-through cable. The modem EIA port will
Step 3
automatically match the 9600 bps setting of the terminal.
Step 4 Enter the commands listed in either Table 15-8 (V.34R modem without talk/data pushbutton) or
Table 15-9 (V.34R modem with talk/data pushbutton), to set up the modem for proper operation.
Note
Step 5 Disconnect the terminal and the straight-through cable from the CONTROL port.
Step 6 Connect the modem to the AUX port by using a null modem cable Figure 15-6.
Ask Cisco Customer Service to assist in testing the operation of the modem setup.
Step 7
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Control
port
1
2
3
4
5
6
20
7
- Frame Ground
- Carrier Detect
- Signal Ground
Consult the manual supplied with your modem for specifics concerning the
modem configuration. Call customer service for latest modem configuration
information.
Modem
connector
1
2
3
4
5
6
20
7
Cisco BPX 8600 Series Installation and Configuration
Connecting Dial-In and Dial-Out Modems
15-13