Installing the T3/E3 Cable Management Tray
This chapter provides instructions for the installation of the optional cable management tray that you
can use to route cables in an open-rack, non-redundant configuration:
•
•
•
•
•
•
You will need to obtain the optional cable management tray kit and one each BXM T3/E3 cable bracket
kit for each BXM T3/E3 card.
Installation of Cable Management Tray
Installing Tray Brackets
Step 1
Obtain brackets and associated hardware from the kit.
Install left and right brackets, using two nuts to secure each bracket, Figure 12-1.
Step 2
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Installation of Cable Management Tray
Raising Tray for Access to PEMs
Installing BXM T3/E3 Cable Bracket
Connecting Cables to BXM T3/E3 Cards
Routing Cables from Cards through Cable Management Tray
Tray Raised with Cables in Place
C H A P T E R
Cisco BPX 8600 Series Installation and Configuration
12
12-1