Configuration: Lines, Trunks, And Connection - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Chapter 6 Installation Overview

Configuration: Lines, Trunks, and Connection

In many cases, you can add and configure lines and trunks by using the Cisco WAN Manager, which
provides a graphical interface that is most convenient for configuring connections. In certain other
cases, however (and particularly during the initial setup before you have configured network
management) you will need to use the command line interface (CLI).
For example, to add an ATM connection, you might use the following CLI command:
Other initial configuration must be performed by using the command line interface:
•
•
•
•
For additional information about the CLI and complete details on all its commands, refer to the Cisco
WAN Switch Command Reference.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
addcon local_addr node remote_addr traffic type ...extended parameters
Configure node name
Configure time zone
Configure date and time
Configure node number
Configuration: Lines, Trunks, and Connection
Cisco BPX 8600 Series Installation and Configuration
6-3