Table; Bxm Front Panel Status Indicators; Bxm Front Panel Card Failure Indicators - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

BXM Front Card Indicators
Types of failures are indicated by various combinations of the card status indicators as described in

Table 5-6.

Table 5-5
Status
port
card
Table 5-6
act
on
off
off
on
Cisco BPX 8600 Series Installation and Configuration
5-10

BXM Front Panel Status Indicators

LED color Status Description
off Trunk/line is inactive and not carrying data.
green Trunk/line is actively carrying data.
yellow Trunk/line is in remote alarm.
red Trunk/line is in local alarm.
green (act) Card is on-line and one or more trunks/lines on the card have been
upped. If off, card may be operational but is not carrying traffic.
yellow (stby) Card is off-line and in standby mode (for redundant card pairs).
May not have any upped trunks/lines. If blinking, indicates card
firmware or configuration data is being updated.
red (fail) Card failure; card has failed self-test and/or is in a reset mode.

BXM Front Panel Card Failure Indicators

stby fail
off on
on on
blinking on
on on
Chapter 5
Failure Description
Non-fatal error detected; card is still active.
Non-fatal error detected; card is in standby mode.
Fatal error detected; card is in a reboot mode.
Card failed boot load and operation is halted.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
BXM Card Sets: T3/E3, 155, and 622