Installing Bxm T3/E3 Cable Bracket; Figure 12-4 Cable Management Tray In Raised Position - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Installing BXM T3/E3 Cable Bracket

To raise the tray to provide access to the PEMs:
Remove the securing screws as necessary.
Step 1
Step 2 With two hands, pull the tray towards youself and up.
Step 3 Raise the tray to the upper position and lower it onto the upper slots.

Figure 12-4 Cable Management Tray in Raised Position

Installing BXM T3/E3 Cable Bracket
To attach the BXM T3/E3 cable bracket to each BXM T3/E3 card as shown in Figure 12-5:
Remove the bracket from the kit.
Step 1
Step 2 Place the bracket in position as shown.
Screw in and tighten the captive screw.
Step 3
Insert one end of the cable tie through the hole in the bracket.
Step 4
Cisco BPX 8600 Series Installation and Configuration
12-4
Chapter 12 Installing the T3/E3 Cable Management Tray
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001