Frame Relay-To-Atm Foresight Network Interworking Connection; Figure 21-14 Atfr Connection Prompt Sequence - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

ATM Connection Configuration

Figure 21-14 ATFR Connection Prompt Sequence

ATFR
PCR(0+1)
%Util
CDVT(0+1)
SCR
MBS
Policing (1, 2, 3, 4, or 5)
VC QDepth
EFCI
IBS
For policing prompt:
1
1 = VBR.1
2 = VBR.2
3 = VBR.3
4 = PCR policing only
5 = policing off
VC QDepth maps to VC Queue Max for frame relay
2
EFCI maps to ECN for frame relay
IBS maps to Cmax for frame relay
Note: FBTC (Frame based traffic control - AAL5,
same as FGCRA) is automatically set to yes.

Frame Relay-to-ATM Foresight Network Interworking Connection

A Frame Relay-to-ATM Foresight (ATFST) connection is a that is configured as an ABR connection
with ForeSight. ForeSight congestion control is automatically enabled when connection type ATFST is
selected. A number of the ATM and Frame Relay connection parameters are mapped between each side
of the connection.
The parameters for an ATFST connection are shown in Figure 21-15 in the sequence in which they
occur during the execution of the addcon command.
Cisco BPX 8600 Series Installation and Configuration
21-38
1
2
Chapter 21 Configuring ATM Connections
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001