Chapter 17
Initial BPX 8600 Node Configuration
Figure 17-3 Configuring the Node Interface for a Local Control Terminal
Log on to
a node
Figure 17-4 Removing a Node From the Network
Log on to
a node
Figure 17-5 Add an Interface Shelf to the Network
Log on to
a node
Summary of Commands
Table 17-1 Here are the names and brief descriptions of each node command:
Table 17-1 Commands for Setting Up a Node
Name
addalmslot
addcdred
addctrlr
addshelf
addyred
cnfasm
cnfdate
cnffunc
cnfname
cnfprt
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Local
Local or
CNFTERM CNFTERMFUNC
remote?
Remote
VT
Local or
remote?
Local
Remote
VT
Local or
remote?
Local
Remote
VT
Description
Add an alarm slot
Add card redundancy for SONET APS 1+1 across two BXM cards
Add a PNNI VSI controller to a BPX node through an AAL5 interface shelf
Add a trunk between an IGX or BPX core switch shelf and an interface shelf
Add Y-cable redundancy
Configure ASM card
Configure date
Configure system function
Configure node name
Configure printing functions
WINDOW
DELTRK
(see chapter 4 for more information)
Another
ADDSHELF
node?
Cisco BPX 8600 Series Installation and Configuration
Summary of Commands
Yes
Another
node?
No
Yes
Another
node?
No
Yes
End
No
:Set-up trunks
End
17-5