Installation with Cisco Cabinets including
7000 Series Routers
This chapter provides these installation procedures:
•
•
Before proceeding with this chapter, complete the procedures and safety checks in:
Installing a BPX Switch in a Cisco Cabinet
Follow the steps in this procedure to install a BPX switch shelf in a Cisco cabinet, using the
factory-installed rear rails located at a 19.86 inch (50.5 cm) setback from the front mounting flanges.
If the BPX switch shelf is DC-powered:
The DC Power Entry Modules are factory-installed in the lower portion of the rear of the BPX switch
shelf (see Figure 8-1). Locate the DC Power Entry Modules and make sure they are equipped as
ordered.
If the BPX switch shelf is AC-powered:
You will also need to install an AC Power Tray below it.
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001
Installing a BPX Switch in a Cisco Cabinet
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
–
Chapter 7, Preliminary Steps Before Installing
C H A P T E R
Cisco BPX 8600 Series Installation and Configuration
8
8-1