Chapter 5
Where to Go Next
Cisco Content Services Switch Routing and Bridging
Configuration Guide
Table 5-3
Cisco Content Services Switch Routing and Bridging Configuration Guide
Chapter
Chapter 1, Configuring
Interfaces and Circuits
Chapter 2, Configuring
Spanning-Tree Bridging
for the CSS
OL-6037-01
This guide describes how to perform routing and bridging configuration tasks on
the CSS.
Table 5-3
lists the chapters in this guide, and a description of their
contents and tasks.
Contents/Tasks
Overview of interfaces and circuit.
•
An interfaces and Virtual LAN (VLAN) circuits quick start.
•
Configuring a Ethernet interfaces including setting the maximum idle
•
time, bridging it to a VLAN circuit, specifying VLAN trunking,
configuring spanning-tree bridging and Port Fast, displaying the
interfaces configuration, and shutting down the interfaces.
Configuring VLAN circuits including configuring a circuit IP
•
interface, configuring Router-Discovery Protocol Settings for a
Circuit, and displaying circuit and IP interface information.
Configuring RIP for an IP interface including a default route, the
•
receive and send versions, and packet logging, and displaying the
configurations.
Configuring the Switched Port Analyzer feature to mirror (copy)
•
traffic passing through one CSS port (Fast Ethernet or Gigabit
Ethernet) to another designated port of the same type and on the same
CSS module for analysis. Instructions to verify the configuration are
also provided.
Spanning-tree protocol (STP) quick start
•
Configuring aging, forward and hello time, priority and max-age
•
Disabling spanning-tree
•
Displaying the bridge configuration
•
Comprehensive CSS Documentation List
Cisco Content Services Switch Getting Started Guide
5-29