Command Line Interface Examples - Cisco BPX-BXM-155-8DX Installation And Configuration Manual

Cisco bpx-bxm-155-8dx: user guide

Hide thumbs

Table of Contents

Configuring BXM Virtual Circuits

Last Command: uptrk 4.1

256 PVCs allocated. Use 'cnfrsrc' to configure PVCs

Next Command:

The initial command to up a trunk (uptrk) or to up a line (upln) on the BXM card

configures all the ports of the card to be either trunks or lines (UNI port access). After

using the uptrk command at each port, use the addtrk command to activate a trunk for

network access.

An example of the cnftrk command for trunk 4.1 of a BXM card:

Transmit Rate:

Protocol By The Card:

Hdr Type NNI:

Statistical Reserve:

Connection Channels:

Traffic:V,TS,NTS,FR,FST,CBR,NRT-VBR,ABR, T-VBR

SVC Vpi Min:

SVC Channels:

SVC Bandwidth:

Restrict CC traffic:

Routing Cost:

This Command: cnftrk 4.1

Transmit Rate [ 1-353208 ]:

An example of the addtrk command:

Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001

Current Line Alarm Status

9.3 Aug. 2 2000 13:42 PDT

9.3 March 2 2000 13:40 PDT

Line framing:

recv impedance:

HCS Masking:

Payload Scramble:

Frame Scramble:

Virtual Trunk Type:

Virtual Trunk VPI:

Deroute delay time:

Cisco BPX 8600 Series Installation and Configuration