Connecting Your Esd Wrist Strap To The Chassis; Installing The Cable Management Frames - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Connecting Your ESD Wrist Strap to the Chassis

Figure 16: Grounding Pad and ESD Port Locations on the Cisco Nexus 7004 Chassis
1 Grounding
pad
Step 5 Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site to ensure an
adequate earth ground for the switch. If the rack is grounded, connect the grounding wire as explained in the documentation
provided by the vendor for the rack.
Connecting Your ESD Wrist Strap to the Chassis
After you connect the chassis to the data center earth ground, you can ground your ESD wrist strap by plugging
it into the ESD port shown by Callout 2 in
Nexus 7004 Chassis, on page

Installing the Cable Management Frames

After you have fastened the chassis to the rack, you can fasten the cable management frames to the front of
the chassis.
To fasten the cable management frames to the chassis, follow these steps:
SUMMARY STEPS
1. Align the guide pin on one of the two cable management frames to a guide-pin hole of the same size on
the front-mounting bracket that is already attached to the chassis. The top of the frame should be at the
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
34
2 ESD
port
34.
Figure 16: Grounding Pad and ESD Port Locations on the Cisco
Installing a Cisco Nexus 7004 Chassis