Accessing The Module Detail Information; Module Details Window - Cisco Prisma II Installation Manual

Accessing the Module Detail Information

The Module Details window displays information about module parameters, alarms,
and status. You can access this window from the module tree using any of these
methods:
Double-click the chassis and select the module in the graphic that appears.

Right-click the chassis and select Open from the menu that appears.

Double-click the module.

Right-click the module and select Details from the menu that appears.

You can use the method most convenient for you. The procedures throughout this
section are described using the right-click module technique.
Note: Two items that may appear in the Module Details window are mode-specific.
Manual Alarm status only appears in the Controls section when Master mode is
selected. Relay status only appears in the Status section when Slave mode is selected.

Module Details Window

The Module Details window displays slightly different information depending on
the module operating mode.
In Single mode, the Module Details screen window appears as shown in the


Accessing the Module Detail Information

119