Telnet Command: Ip6 Dhcp Server - Draytek Vigor2860 Series User Manual

E x a m p
E x a m p
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> system reboot
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure DHCPv6 server.
ip6 dhcp server [-<command> <parameter>| ... ]
S y n t a x
S y n t a x
Parameter
server
[<command>
<parameter>|...]
-a
-i<pool_min_addr>
-x<pool_max_addr>
-d<addr>
-D<addr>
Vigor2860 Series User's Guide
l e
l e
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
a n d : i p 6 d h c p s e
a n d : i p 6 d h c p s e
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means the dhcp server settings.
The available commands with parameters are listed
below.
[...] means that you can type in several commands in
one line.
It means to show current DHCPv6 status.
It means to set the start IPv6 address of the address
pool.
It means to set the end IPv6 address of the address
pool.
It means to set the first DNS IPv6 address.
It means to set the second DNS IPv6 address.
1: Enable
0: Disable
r v e r
r v e r
612