Telnet Command: Msubnet Pppip - Draytek Vigor2860 Series User Manual

%Set LAN2 Dhcp Start IP done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> msubnet startip ?
% msubnet startip <2/3/4/5/6> <Gateway IP>
% Now: LAN2 192.168.2.90; LAN3 192.168.3.10; LAN4 192.168.4.10; LAN5
192.168.5.1
0; LAN6 192.168.6.10
T e l n e t C o m m
T e l n e t C o m m
This command is used to configure a starting IP address for PPP connection.
msubnet pppip [2/3/4/5/6] [Start IP]
S S y y n n t t a a x x
Parameter
2/3/4/5/6
Start IP
E x a m p
E x a m p
> msubnet pppip 2 192.168.2.250
% Set LAN2 PPP(IPCP) Start IP done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
> msubnet pppip ?
% msubnet pppip <2/3/4/5/6> <Start IP>
% Now: LAN2 192.168.2.250; LAN3 192.168.3.200; LAN4 192.168.4.200; LAN5
192.168.5.200; LAN6 192.168.6.200
Vigor2860 Series User's Guide
a n d : m s u b n e t p p
a n d : m s u b n e t p p
D D e e s s c c r r i i p p t t i i o o n n
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
5=LAN5
6=LAN6
Type an IP address as the starting IP address for PPP
connection.
l e
l e
p i p
p i p
652