Telnet Command: Wan Detect - Draytek Vigor2860 Series User Manual

ADSL
Link Status:
Firmware Version:
ADSL Profile:
Basic Status Upstream
Actual Data Rate:
SNR:
> wan vdsl fbk_mode vdsl_only
Set VDSL fallback mode to VDSL ONLY
Reboot system to take effect
>
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
wan detect [wan1]ttl [1-255]
wan detect status
S y n t a x D e
S y n t a x D e
Parameter
on
off
always_on
target
ip addr
ttl
status
TRAINING
05-04-04-04-00-01
0
0 0 0.1dB
: w a n d e t e c t
: w a n d e t e c t
s c r i p t i o n
s c r i p t i o n
Description
It means to enable ping detection. The IP address of the
target shall be set.
It means to enable ARP detection (default).
disable link detect, always connected(only support static
IP)
It means to set the ping target.
It means the IP address used for detection. Type an IP
address in this field.
It means to set the ping TTL value (work as trace route)
If you do not set any value for ttl here or just type 0 here,
the system will use default setting (255) as the ttl value.
It means to show the current status.
Downstream
0 Kb/s
751
Unit
Vigor2860 Series User's Guide