Draytek Vigor2860 Series User Manual page 399

Hide thumbs Also See for Vigor2860 Series:

Table of Contents

Aggregation MSDU

Long Preamble

Packet-OVERDRIVE

After finishing all the settings here, please click OK to save the configuration.

for data transmit based on the station capability.

Aggregation MSDU can combine frames with different sizes

It is used for improving MAC layer's performance for some

brand's clients. The default setting is Enable.

This option is to define the length of the sync field in an

802.11 packet. Most modern wireless network uses short

preamble with 56 bit sync field instead of long preamble with

128 bit sync field. However, some original 11b wireless

network devices only support long preamble. Click Enable to

use Long Preamble if needed to communicate with this kind

This feature can enhance the performance in data

transmission about 40%* more (by checking Tx Burst). It is

active only when both sides of Access Point and Station (in

wireless client) invoke this function at the same time. That is,

the wireless client must support this feature and invoke the

function, too.

Note: Vigor N61 wireless adapter supports this function.

Therefore, you can use and install it into your PC for

matching with Packet-OVERDRIVE (refer to the following

picture of Vigor N61 wireless utility window, choose Enable

for TxBURST on the tab of Option).

Note: * means the real transmission rate depends on the

environment of the network.

Set the power percentage for transmission signal of access

point. The greater the value is, the higher intensity of the

signal will be.

Vigor2860 Series User's Guide