Telnet Command: Apm Napdetect - Draytek Vigor2860 Series User Manual

1. Enable LoadBalance : 0
2. Enable station limit : 0
3. Enable traffic limit : 0
4. limit Number : 64
5. Upload limit : 0
6. Download limit : 0
7. Enable disassociation by idle time : 0
8. Enable disassociation by Signal strength : 0
9. Traffic limit unit (upload)
10.Traffic limit unit (download) : 0
flag : 0
> apm lbcfg set 1 1 0 15 0 0 0 0 1 1
> apm lbcfg show
apm LoadBalance Config :
1. Enable LoadBalance : 1
2. Enable station limit : 1
3. Enable traffic limit : 0
4. limit Number : 15
5. Upload limit : 0
6. Download limit : 0
7. Enable disassociation by idle time : 0
8. Enable disassociation by Signal strength : 0
9. Traffic limit unit (upload)
10.Traffic limit unit (download) : 1
flag : 49
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command is used to enable/disable AP detection function.
apm napdetect [get]
apm napdetect [set] [enable/disable AP Detection 1/0][Refresh Time].
S y n t a x D e
S y n t a x D e
Parameter
get
set
: a p m n a p d e t e c
: a p m n a p d e t e c
s c r i p t i o n
s c r i p t i o n
Description
It is used to get AP detection data from VigorAP (e.g.,
AP900).
It allows to set detect configuration to VigorAP.
: 0
: 1
t
t
779
Vigor2860 Series User's Guide