Telnet Command: Ip6 Dhcp Client - Draytek Vigor2860 Series User Manual

-B
-r
Parameter
E x a m p l e
E x a m p l e
> ip6 dhcp req_opt WAN2 -S 1
> ip6 dhcp req_opt WAN2 -r 1
> ip6 dhcp req_opt WAN2 -a
% Interface WAN2 is set to request following DHCPv6 options:
% sip name
>
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to use DHCPv6 protocol to obtain IPv6 address from server.
ip6 dhcp client [WAN1|WAN2|iface#] [-<command> <parameter>| ... ]
S y n t a x D e
S y n t a x D e
Parameter
client
[<command>
<parameter>|...]
-a
-p [IAID]
-n [IAID]
-c [parameter]
-i [parameter]
-e[parameter]
It means to ask BCMCS name.
It means to ask refresh time.
1: the parameter related to the request will be displayed.
0: the parameter related to the request will not be
displayed.
: i p 6 d h c p c l i e n t
: i p 6 d h c p c l i e n t
s c r i p t i o n
s c r i p t i o n
Description
It means the dhcp client settings.
The available commands with parameters are listed
below.
[...] means that you can type in several commands in
one line.
It means to show current DHCPv6 status.
It means to request identity association ID for Prefix
Delegation.
It means to request identity association ID for
Non-temporary Address.
It means to send rapid commit to server.
It means to send information request to server.
It means to enable or disable the DHCPv6 client.
611
Vigor2860 Series User's Guide