For Vigor2860Ac / Vigor2860N-Plus / Vigor2860N - Draytek Vigor2860 Series User Manual

1 . 2 . 2 F o r V i g o r 2 8
1 . 2 . 2 F o r V i g o r 2 8
LED
ACT (Activity)
WAN2
QoS
USB
DSL
WCF
2.4G/5G/WLAN
VPN
DoS
LED on Connector
Left
WAN2
LED
(Giga)
6 0 a c / V i g o r 2 8 6 0
6 0 a c / V i g o r 2 8 6 0
Status
Blinking
Off
On
Off
Blinking
On
On
Blinking
On
Blinking
On
On
Blinking
On
Off
Blinking
On
Blinking
On
Off
Blinking
n - p l u s / V i g o r 2 8 6
n - p l u s / V i g o r 2 8 6
Explanation
The router is powered on and running normally.
The router is powered off.
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The QoS function is active.
USB device is connected and ready for use.
The data is transmitting.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
The Web Content Filter is active. (It is enabled from
Firewall >> General Setup).
2.4G/5G: Wireless access point with bandwidth of
2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
The VPN tunnel is active.
VPN services are disabled.
Traffic is passing through VPN tunnel.
The DoS function is active.
It will blink while detecting an attack.
The port is connected.
The port is disconnected.
The data is transmitting.
5
0 n
0 n
Vigor2860 Series User's Guide