Draytek Vigor2860 Series User Manual page 641

- p [VALUE]
-M [P2P_NO]
-U [URL_NO]
-a [AD_SET]
-f [VALUE]
-E [VALUE]
-F [VALUE]
-Q [VALUE]
E E x x a a m m p p l l e e
> ipf set -c 1 #set call filter start from set 1
Setting saved.
> ipf set -d 2 #set data filter start from set 2
Setting saved.
> ipf set -v
Type "0" to disable the log flag.
Type "1" to display the log of passed packet.
Type "2" to display the log of blocked packet.
Type "3" to display the log of non-matching packet.
It means to setup actions for packet not matching any
rule, e.g., -p 1
Type "0" to let all the packets pass;
Type "1" to block all the packets.
It means to configure IM/P2P for the packets not
matching with any rule, e.g., -M 1
Type "0" to let all the packets pass;
Type "1" to block all the packets.
It means to configure URL content filter for the packets
not matching with any rule, e.g., -U 1
Type "0" to let all the packets pass;
Type "1" to block all the packets.
It means to configure the advanced settings.
It means to accept large incoming fragmented UDP or
ICMP packets.
It means to set the maximum count for session
limitation.
It means to configure the load-balance policy.
It means to set the QoS class.
627
Vigor2860 Series User's Guide