Telnet Command: Mngt Snmp - Draytek Vigor2860 Series User Manual

mask
remove
flush
E x a m p
E x a m p
> mngt accesslist add 1 192.168.1.89 255.255.255.0
%% Set OK.
> mngt accesslist list
%% Access list :
Index IP address
==========================================
1
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure SNMP for management.
mngt snmp [-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-e <1/2>
-g<Community name>
-s <Community name>
-m <IP address>
-t <Community name>
Vigor2860 Series User's Guide
It means to specify the subnet mask for the IP address.
It means to delete the selected item.
It means to remove all the settings in the access list.
l e
l e
192.168.1.89
a n d : m n g t s n m p
a n d : m n g t s n m p
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed
below.
[...] means that you can type in several commands in
one line.
1: Enable the SNMP function.
2: Disable the SNMP function.
It means to set the name for getting community by
typing a proper character. (max. 23 characters)
It means to set community by typing a proper name.
(max. 23 characters)
It means to set one host as the manager to execute
SNMP function. Please type in IPv4 address to specify
certain host.
It means to set trap community by typing a proper name.
(max. 23 characters)
Subnet mask
255.255.255.0
644