Draytek Vigor2860 Series User Manual page 93

Enable
Physical Mode / Type
Line Speed(Kbps)
DownLink/UpLink
Active Mode
Note: In default, each WAN port is enabled.
After finished the above settings, click OK to save the settings.
W A N 1 w i t h A D S L /
W A N 1 w i t h A D S L
Vigor router will detect the physical line is connected by ADSL or VDSL2 automatically.
Therefore, this page allows you to configure settings for ADSL and VDSL2 at one time. That
is, it is not necessary for you to configure different profile settings for ADSL and VDSL2
respectively.
Available settings are explained as follows:
Item
Enable
V means such WAN interface is enabled and ready to be
used.
Display the physical mode and physical type of such WAN
interface.
Display the downstream and upstream rate of such WAN
interface.
Display whether such WAN interface is Active device or
backup device.
Backup (WAN#)- Display the backup WAN interface for
such WAN when it is disabled.
V D S L
/ V D S L
Description
Choose Yes to invoke the settings for this WAN interface.
Choose No to disable the settings for this WAN interface.
79
Vigor2860 Series User's Guide