ABB IRC5 Product Manual page 244

4 Repair
4.12 Replacement of SD-card memory in computer unit
Continued
Required equipment
Equipment
SD-card 2GB
Standard toolkit
Removal
Use the following procedure to remove the SD-card memory.
1
2
3
Refitting
Use the following procedure to refit the SD-card memory.
1
2
3
Continues on next page
244
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety inform-
ation in section Make sure that the main power has been switched off on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit please observe the safety
information in section
Gently push the SD-card memory with your finger until it clicks, and then pull it
straight out.
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety information
in section Make sure that the main power has been switched off on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit please observe the safety inform-
ation in section The unit is sensitive to ESD on page 34
CAUTION
Make sure that the SD-card memory is correctly oriented before inserting it. Otherwise
the SD-card memory or the SD-card memory slot may be damaged.
© Copyright 2004-2018 ABB. All rights reserved.
Note
See Spare parts on page
Only use SD-card memory supplied by
ABB.
Includes ABB Boot Application software
to correctly reboot the robot controller.
The content is described in section
Standard toolkit, IRC5 on page
The unit is sensitive to ESD on page 34
307.
Note
305.
26.
Product manual - IRC5
3HAC047136-001 Revision: M
26.