System Access; Administrative User; Remote Access - Cisco UC320W Administration Manual

Site

System Access

System Access
Cisco Unified Communications UC320W Administration Guide
Configuration > Site > System Access
Use the
username and password. Optionally, enable access to this utility from the WAN
and the wireless network.
Note:
• Changes in the username and password take effect after you apply a
configuration.
• The configuration utility allows only one session at a time.

Administrative User

To change the username and password, click the Change administrator
username/password button. Then enter the following information:
• Admin Username: Enter a username for the system administrator. The first
character must be a letter. The following characters are valid: A-Z a-Z 0-9
cisco
!*_.( ) Neither
• Password: Enter a password for the system administrator. The password
must begin with a letter and is case sensitive. Neither
allowed in any form. To help prevent unauthorized access, you should use a
strong password that includes lowercase and uppercase letters and
numbers.
• Confirm Password: Enter the same password again, for confirmation. The
passwords must match.

Remote Access

• Enable remote management of the Cisco UC320W via HTTPS: Check
this box to allow access to the configuration utility from the WAN side of the
Cisco UC320W. After enabling this option, you can access the configuration
utility from the WAN by entering the Cisco UC320W WAN IP address and
the port number, as shown in the following example:
WAN_ipaddress:8080
another port number. As shown in the example, a port number is required
when entering the address.
admin
nor is allowed in any form.
. Keep the default port number shown, or enter
page to update the administrator
cisco
nor
https://
2
admin
is
20