Integrating Voice Mail with Cisco Unified SRST
How to Integrate Voice Mail with Cisco Unified SCCP and SIP
SRST
This section contains the following tasks:
•
•
•
•
•
Support for SIP SRST is added from IOS release 15.1(4)M3 and 15.2(1)T2.
Note
Configuring Direct Access to Voice Mail
To access voice-mail messages with FXO or FXS access, you must have POTS dial peers configured with
a destination pattern that matches the voice-mail system's number. Also, you must associate the dial peer
with the port to which the voice-mail system is accessed.
Both sets of configurations are done in global configuration mode and in dial-peer configuration mode.
The summary and detailed steps below include only the basic commands necessary to perform this task.
You may require additional commands for your particular dial-peer configuration.
SUMMARY STEPS
1.
2.
3.
4.
5.
OL-13143-04
Configuring Direct Access to Voice Mail, page 237
Configuring Message Buttons, page 240
Redirecting to Cisco Unified Communications Manager Gateway, page 243
PRI))
Configuring Call Forwarding to Voice Mail, page 243
Configuring Message Waiting Indication, page 247
dial-peer voice tag {pots | voatm | vofr | voip}
destination-pattern [+] string [T]
port {slot-number/subunit-number/port | slot/port:ds0-group-no}
forward-digits {num-digit | all | extra}
exit
How to Integrate Voice Mail with Cisco Unified SCCP and SIP SRST
(Required)
(Required)
(Required FXO or FXS)
(Optional)
Cisco Unified SCCP and SIP SRST System Administrator Guide
(Required for BRI or
237