Connecting A Pc To A Phone (Optional); Upgrading The Phone Firmware; Connecting Attendant Consoles - Cisco UC320W Administration Manual

Installing the UC 320W and Phones

Connecting a PC to a Phone (Optional)

Connecting a PC to a Phone (Optional)

STEP 1
STEP 2

Upgrading the Phone Firmware

Connecting Attendant Consoles

Cisco Unified Communications UC320W Administration Guide
PC ports are not available on Cisco SPA300 Series phones.
A PC cannot be connected to Cisco SPA525 models that are connected to the
wireless network.
To provide network access to a PC, connect one end of an additional Ethernet
cable (not provided) to the PC port on the back of the phone body. See the
illustrations in the Phone Connections, page
Connect the other end of the Ethernet cable to the network port on the PC.
After receiving power and network connectivity, the phone executes a boot-up
sequence. During this sequence, phones with screens display the Cisco logo and
then "Initializing Network." All of the lights on the phone will flash.
After your phone is successfully connected to the network, it receives a basic
configuration. On all models except Cisco SPA501G, the time, date, extension
number, and softkeys appear on the display screen. On Cisco SPA501G, which
has no display screen, you should hear a dial tone when picking up the handset or
pressing the speakerphone button.
If the phone does not start, confirm your installation and connections. If these are
correct, try unplugging the phone and plugging it back in again.
Use the 320W Configuration Utility to upgrade the firmware for all components of
the Unified Communications system.
For extra line buttons, you can connect up to two Cisco SPA500S Attendant
Consoles to a Cisco SPA500 Series IP phone. Before you begin, you need the
following items:
• Cisco SPA500S Attendant Console
107.
B
119