Cisco UC320W Administration Manual page 122

Installing the UC 320W and Phones
Connecting Attendant Consoles
STEP 7
Cisco Unified Communications UC320W Administration Guide
If you need to attach another attendant console, position it next to the first, and
complete the tasks described below. If you have only one attendant console, omit
this step.
1 Screw holes
3 AUX IN port
5 AUX OUT port
a. Align the attachment arm over the peg holes on the right side of the first Cisco
SPA500S and the left side of the second Cisco SPA500S. Insert the attachment
arm pegs into the peg holes.
b. Using the attachment arm screws, secure the attachment arm to the two
attendant consoles.
c. Locate the AUX OUT port on the back of the first Cisco SPA500S. Connect one
end of the auxiliary cable to this port.
d. Locate the AUX IN port on the back of the second Cisco SPA500S. Connect the
other end of the auxiliary cable to this port. Do not plug a phone line cord into
the AUX port. Use
e. Route the auxiliary cable inside the cable slot. Cisco SPA500S is powered by
the auxiliary cable with the IP phone; no additional power source is required.
2 Peg holes
4 Cable slot
only the auxiliary cable provided with Cisco SPA500S.
B
122