Apply Configuration - Cisco UC320W Administration Manual

Apply Changes

Apply Configuration

Apply Configuration
Cisco Unified Communications UC320W Administration Guide
Apply Changes > Apply Configuration
Use the
you apply the configuration, all devices will restart, and phone service will be
interrupted. If a call is in progress, the phone will not reboot until completion of the
call.
You can apply the configuration only if there are no errors on the configuration
screens. If there are errors, the Apply Configuration button is unavailable, and a
message appears at the bottom of the screen. To find the errors, look for red X
icons in the navigation tree. Open the indicated pages, and fix the problems before
attempting to apply the configuration.
Tip: If you are not ready to apply your changes, you can continue working on other
configuration pages. Return to this page when you are ready to apply the
configuration. If you want to apply your configuration settings at a later time or
date, you can use the Save button to save your session.
• To apply the new settings: Click Apply All Changes. When the
confirmation appears, click OK to continue, or click Cancel to close the
window without applying the configuration. After you apply a configuration,
wait for the Cisco UC320W and all connected devices to restart. However, if
a call is in progress, the phone will not reboot until completion of the call. If
any error messages appear at the bottom of the screen, refer to the
navigation tree to find the pages that are marked with the red X error icon.
Fix the problems on those pages before you apply your configuration.
• To view the system status: Click Finish and View System Status. This
button appears after you apply all changes. After you click this button, you
will be redirected to the System Status page.
page to apply your settings. When
10
85