Settings For Shared Fxo Lines - Cisco UC320W Administration Manual

Extension Buttons
Shared FXO Lines
Cisco Unified Communications UC320W Administration Guide

Settings for Shared FXO Lines

• Shared FXO Line Settings: This button is available after you enter a label.
Click this button to open or close the Settings section.
• To assign or unassign an FXO trunk: To assign an FXO trunk to a Shared
FXO Line, use your mouse to drag the trunk from the Available FXO Trunks
list to the Assigned FXO Trunks list. An icon appears in the Available FXO
Trunks list to indicate that the trunk is assigned to the specified Shared FXO
Line. To unassign an FXO trunk, drag it from the Assigned FXO Trunks list to
the Available FXO Trunks list.
• Night Route: Available only if you enabled Day/Night call routing on the
Day/Night Features page. Choose a destination for inbound calls when the
system is in Night mode. Calls will be forwarded immediately to the
specified destination.
• Shared Voicemail Box: Check this box to create a voicemail box for this
Shared FXO Line. The mailbox number is displayed. The default mailbox
password is 12345. Uncheck this box if voicemail is not required. You can
edit the mailbox number, if needed. Any user can leave a message in this
voicemail box by dialing the voicemail access digit (default 7) and the
mailbox number, as shown on the screen. To retrieve messages for this
Shared FXO Line, a user can dial the Voicemail Pilot extension number and
enter the mailbox number (without the 7) and the password. The line button
on the phone will display an envelope icon to indicate new messages.
Note: The system allows up to 25 voicemail boxes for primary personal
extensions and 15 voicemail boxes for additional extensions and group
extensions. Each voicemail box can store up to 30 minutes of messages.
• Include in outbound dialing: Check this box if you want to include the
specified FXO trunk in the pool of lines that can be seized for outbound calls
by all users. Uncheck this box if you want allow the specified FXO trunk to
be used only when someone presses this Shared FXO Line button. If you
uncheck this box, ensure that at least one FXO trunk is unassigned and
remains available for outbound calling by other users.
• If busy or no answer, forward to: Available after you apply the initial
configuration. During the initial setup, you can set call forwarding on the Call
Forwarding page. Use the first drop-down list to choose a destination for an
unanswered call. Use the second drop-down list to specify the timeout
period in seconds. Note: If you choose None for the destination, the timeout
setting is unavailable. The phone rings until the caller disconnects or the
phone is answered.
6
50