Automatic Maintenance; Maintenance Window - Cisco UC320W Administration Manual

Site

Automatic Maintenance

Automatic Maintenance
Cisco Unified Communications UC320W Administration Guide
Note:
- Do not change the port number to 443. Because this port is used by SSL
and HTTPS, web browsers tend to remove it from a URL when entered.
However, the configuration utility requires a port number to be specified.
- A remote management session is disconnected after a long idle time.
- If the Cisco UC320W is located behind another router, you may need to
configure port forwarding on that router to allow traffic from the WAN to
the Cisco UC320W.
• Enable wireless management of the Cisco UC320W: Check this box to
allow access to the configuration utility from a computer that is connected
to the wireless network. Be aware of security issues when submitting
passwords wirelessly. Do not use a wireless connection to upgrade the
firmware or to back up the configuration.
Configuration > Site > Automatic Maintenance
Use the
maintenance tasks and to enable automated backups to a USB key.

Maintenance Window

Automatically, on the specified schedule, the Cisco UC320W runs diagnostics. At
the end of this process, the Cisco UC320W reboots. Schedule a convenient time
when your users will not be impacted.
• Time: Choose the time of day to perform the maintenance tasks, including a
system reboot.
• Day: Choose a day. The maintenance tasks will be performed automatically
each week on the specified day.
2
page to schedule system
21