Cisco Spa303 And Spa500 Series Connections - Cisco UC320W Administration Manual

Installing the UC 320W and Phones
Phone Connections
Cisco Unified Communications UC320W Administration Guide
1. Power port: Use this port to connect the supplied power cord. Note: This phone
can receive power over Ethernet only if a Cisco POES5 5-Volt Power Over
Ethernet Splitter accessory is connected.
2. Handset port: Insert the long end of the phone cord into this port, which is
marked with a phone symbol. Insert the short end of the phone cord into the port
at the bottom of the handset (not shown).
3. WAN port: Insert one end of an Ethernet cable into the network port on the
phone body marked WAN. Insert the other end of the Ethernet cable into the
appropriate device, such as a network switch, on your network.

Cisco SPA303 and SPA500 Series Connections

1. Desk stand slots: Use these slots to connect the desk stand. See
Desk Stand (Optional), page
2. PC: Use this port to connect a PC to the phone for the purpose of sharing the
same Ethernet connection.
3. SW: Use this port to connect the phone to an Ethernet switch. It also can be used
to connect directly to a LAN port of the Unified Communications System.
4. Phone cable channel: Optionally, thread the long end of the phone cord through
this channel.
109.
B
Installing a
108