Adding And Removing Cisco Spa8800 Ip Telephony Gateways; Adding And Removing Ip Phones And Side Cars - Cisco UC320W Administration Manual

Telephony
Devices
Cisco Unified Communications UC320W Administration Guide
up to 30 phones on this page. However, the Cisco UC320W supports
only 24 users (not counting the built-in FXS port on the Cisco UC320W).
Adding and Removing Cisco SPA8800 IP Telephony
Gateways
You can manually add a Cisco SPA8800 IP telephony gateway that you intend to
connect later.
• Create a SPA8800: Click this button to enter information for a Cisco
SPA8800 that is not yet connected.
• Description: Enter a short description to identify this device on the pages
of the configuration utility.
• MAC Address: Enter the MAC address in the following format:
xxxx.xxxx.xxxx
address can be found on the hardware label on the bottom panel of the
device.
• To remove a manually added gateway or missing/unregistered gateway
from the list: Click the delete button (X) for the gateway that you want to
remove. When the confirmation message appears, click OK to delete the
device, or click Cancel to keep the device.

Adding and Removing IP Phones and Side Cars

You can manually add an IP phone that you intend to connect later. You also can
indicate the number of connected side cars for each phone that you add.
Alternatively, you can add phones by importing a list.
• Create a phone: Click this button to enter information for an IP phone that is
not yet connected.
• MAC Address: Enter the MAC address of the phone in the following format:
xxxx.xxxx.xxxx
address can be found on the hardware label on the bottom panel of the
phone.
• Model: Choose the phone model.
• Side Cars: Choose the number of side cars that are attached to this phone.
• To download a CSV file as a template for data entry or as a phone list:
Click the Download icon to save a CSV file to use as a template. If you have
, where x is a number or letter in the MAC address. The MAC
, where x is a number or letter in the MAC address. The MAC
3
24