Cisco UC320W Administration Manual page 120

Installing the UC 320W and Phones
Connecting Attendant Consoles
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Unified Communications UC320W Administration Guide
• Attachment Arm
• Two (2) Attachment Arm Screws
• Auxiliary Interconnect Cable
• Stand
Place the IP phone and Cisco SPA500S face down on a flat surface, with Cisco
SPA500S on the left.
Align the attachment arm over the peg holes on the right side of the phone and the
left side of Cisco SPA500S. Insert the attachment arm pegs into the peg holes.
Using the attachment arm screws, secure the attachment arm to the phone and
Cisco SPA500S.
Locate the AUX IN port on the back of Cisco SPA500S. Connect one end of the
auxiliary cable to this port.
Locate the AUX port on the back of the IP phone. Connect the other end of the
auxiliary cable to this port. Cisco SPA500S is powered by the auxiliary cable with
the IP phone; no additional power source is required.
B
120