Configuring Contact Information - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring Contact Information

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Step 2 Configure destination profiles.
Associate one or more alert groups to each profile as required by your network. Customize the alert
Step 3
groups, if desired.
Step 4 Configure e-mail options.
Step 5 Enable or disable Call Home.
Test Call Home messages.
Step 6
Configuring Contact Information
Each switch must include e-mail, phone, and street address information. You can optionally include the
contract ID, customer ID, site ID, and switch priority information.
Switch priority is specific to each switch in the fabric. This priority is used by the operations personnel
Note
or TAC support personnel to decide which Call Home message they should respond to first. You can
prioritize Call Home alerts of the same severity from each switch.
To assign the contact information, follow these steps:
Command
Step 1
switch# config t
Step 2
switch# snmp-server contact
personname@companyname.com
Step 3
switch(config)# callhome
switch(config-callhome)#
Step 4
switch(config-callhome)# e-mail-contact
username@company.com
Step 5
switch(config-callhome)# phone-contact
+1-800-123-4567
Step 6
switch(config-callhome)# streetaddress 1234
Picaboo Street, Any city, Any state, 12345
Step 7
switch(config-callhome)# switch-priority 0
Cisco MDS 9000 Family CLI Configuration Guide
53-6
Chapter 53
Purpose
Enters configuration mode.
Configures the SNMP contact name.
Enters the Call Home configuration submode.
Assigns the customer's e-mail address. Up to 128
alphanumeric characters are accepted in e-mail
address format.
Note You can use any valid e-mail address.
You cannot use spaces.
Assigns the customer's phone number. Up to 20
alphanumeric characters are accepted in
international format.
You cannot use spaces. Be sure to use the
Note
+ prefix before the number.
Assigns the customer's street address where the
equipment is located. Up to 256 alphanumeric
characters are accepted in free format.
Assigns the switch priority, with 0 being the
highest priority and 7 the lowest.
Use this field to create a hierarchical
Tip
management structure.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring Call Home