Configuration In The Destination Switch - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Remote SPAN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To create a VSAN interface in the destination switch for the scenario in
follow these steps:
Command
Step 1
switchD# config t
Step 2
switchD(config)# interface vsan 5
switchD(config-if)#
Step 3
switchD(config-if)# ip address
10.10.10.2 255.255.255.0
Step 4
switchD(config-if)# no shutdown
Enabling FC Tunnels
To enable the FC tunnel feature, follow these steps:
Command
Step 1
switchS# config t
Step 2
switchS(config)# fc-tunnel enable
Be sure to enable this feature in each switch in the end-to-end path in the fabric.
Note
Enabling IP Routing
The IP routing feature is disabled by default. Be sure to enable IP routing in each switch (including the
source and destination switches) in the end-to-end path in the fabric (see the
section on page

Configuration in the Destination Switch

This section identifies the tasks that must be performed in the destination switch (Switch D):
•
•
•
Configuring VSAN Interfaces
Figure 51-12 on page 51-25
switch (Switch D).
Note This example assumes that VSAN 5 is already configured in the VSAN database.
Cisco MDS 9000 Family CLI Configuration Guide
51-24
44-7). This step is required to set up the FC tunnel.
Configuring VSAN Interfaces, page 51-24
Configuring the SD Port, page 51-25
Mapping the FC Tunnel, page 51-26
depicts an RSPAN tunnel configuration terminating in the destination
Chapter 51 Monitoring Network Traffic Using SPAN
Figure 51-12 on page
Purpose
Enters configuration mode.
Configures the specified VSAN interface (VSAN 5) in
the destination switch (Switch D).
Configures the IPv4 address and subnet for the VSAN
interface in the destination switch (Switch D).
Enables traffic flow to administratively allow traffic
(provided the operational state is up).
Purpose
Enters configuration mode.
Initiates the FC tunnel (100) in the source switch
(switch S). The tunnel IDs range from 1 to 255.
OL-18084-01, Cisco MDS NX-OS Release 4.x
51-25,
"Enabling IPv4 Routing"