Power On/Boot Up; Detailed Procedure; Warnings - GE LOGIQ E9 Service Manual

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5180483-100, R

Power On/Boot Up

ALWAYS CONNECT THE UNIT TO A FIXED POWER SOCKET WHICH HAS THE

PROTECTIVE GROUNDING CONNECTOR.

NEVER USE A THREE-TO-TWO PRONG ADAPTER; THIS DEFEATS THE

SAFETY GROUND.

ENSURE THAT THE POWER CORD AND PLUG ARE INTACT AND THAT THE

POWER PLUG IS THE PROPER HOSPITA L-GRADE TYPE (WHERE REQUIRED).

LOGIQ E9 REQUIRES ALL COVERS

OPERATE THIS UNIT ONLY WHEN ALL BOARD COVERS AND FRAME PANELS ARE

SECURELY IN PLACE. THE COVERS ARE REQUIRED FOR SAFE OPERATION, GOOD LOGIQ E9

PERFORMANCE AND COOLING PURPOSES.

Use only power supply cords, cables and plugs provided by or designated by GE.

Do not cycle the Circuit Breaker ON-OFF-ON in less than five seconds. When turning OFF the

Circuit Breaker, WAIT until the ON/OFF button is no longer lit. The LOGIQ E9 should de-

energize completely before turning the circuit breaker ON.

For a detailed procedure, see:

PROPRIETARY TO GE

4-2-3 "Power ON/Boot Up" on page

Section 3-6 - Completing the setup