Connect Usb Flash Drive - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
3-6-5-1 Connect Ethernet (cont'd)
Figure 3-14 Audio (1), Ethernet (2), DVI-I (3) and SVHS (4) connection for External Monitor on
rear side of LOGIQ E9 - R4.x and Later
To avoid breaking the back cover while opening it in order to connect up the network cable, use
CAUTION
a flat blade screw driver or plastic card and pull hard to open up the back cover door.
SVHS Specifications for BEP6
• DVI-I delivering both analog RGB and digital DVI out the rear customer accessible DVI-I port.
• The DVI-I output support a fixed 1280x1024 resolution @60Hz 24 bit color depth.
-
• The DVI-D Video output deliver a minimum of 1280x1024 @60Hz 24-bit color depth.
3-6-5-2

Connect USB Flash Drive

Refer to the current revision of the LOGIQ E9 Basic User Manual, Chapter 3, Section 7.
PROPRIETARY TO GE
. 7
EV
2
L R
1
NOTE: Any display connected to the DVI-I output is intended to serve as a clone of the image
on the main display. In the event that a display connected to DVI-I video output is not capable
of displaying the resolution being used by the main display, then the auxiliary display will be
blank or show a "no-signal" message.
Chapter 3 LOGIQ E9 Setup
LOGIQ E9 P
4 3
2 1
4 3
S M
ROPRIETARY ERVICE ANUAL
3 - 21