Siemens SINUMERIK 840D Series Diagnostics Manual page 61

11.02
6100
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6401
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Error while creating %1, error number %2 %3
%1 = Symbol name
%2 = Error code
%3 = If required, internal error identifier
An error was detected while creating a compile cycle machine data. The error number
specifies the type of error.
• Error number 1: Insufficient memory available
• Error number 2: Symbol in the NCK already exists
• Error number 3: Maximum possible number of symbols exceeded
• Error number 4: Invalid name prefix
• Error number 5: Illegal array size
Note: Other errors of this type could have occurred, but have not been displayed.
- Alarm display.
- Interface signals are set.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- NC Stop on alarm.
• Error number 1: The memory reserved by machine data 12238
$MN_MM_CC_MD_MEM_SIZE has to be increased. If the error occurs while loading
an archive, then the machine data must be increased "manually". To do this, either Edit
the archive with 'arcedit' or Overwrite the MD in the MD picture and prevent the deletion
of the machine data when writing the archive (MMC: Set Ask_for_CFG_RESET.INI = 1
in 'dino.ini'). Also refer to: Upgrade instructions P6.x.
• Error number 2: Error in the combination or while reloading compile cycles: Do not acti-
vate compile cycle.
• Error number 3: Error in the combination or while reloading compile cycles: Do not acti-
vate compile cycle.
• Error number 4: Error in the compile cycle: Do not activate compile cycle.
• Error number 5: Error in the compile cycle: Do not activate compile cycle.
Switch control OFF - ON.
Channel %1 tool change not possible: Empty location for tool %2 Duplo no. %3 on
magazine %4 not available.
%1 = Channel ID
%2 = String (identifier)
%3 = Duplo number
%4 = Magazine number
The tool cannot be moved into the selected tool magazine. There is no appropriate loca-
tion for this tool. A suitable location is mainly determined by the status. The status must
indicate that this location is free, not disabled, not reserved and not co-occupied by a tool
that is too large. Furthermore, it is important that the type of tool matches the type of any
magazine location that may be free. (If, for example, all magazine locations are of the 'B'
type and these are all free and the tool is of type 'A', then this tool cannot be put into this
magazine).
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- NC Stop on alarm.
1 Alarms
1-61