Siemens SINUMERIK 840D Series Diagnostics Manual page 122

1 Alarms
Remedy:
Program Continuation:
10960
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10961
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10962
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-122
Delete the curve tables that are no longer required in the DRAM or reconfigure the mem-
ory space for the curve tables. The curve table must then be redefined. Machine data for
memory configuration of the curve tables in DRAM:
MN_MM_NUM_CURVE_TABS_DRAM, MN_MM_NUM_CURVE_SEGMENTS_DRAM,
MN_MM_NUM_CURVE_POLYNOMS_DRAM.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 COMPCURV/COMPCAD and radius compensation cannot be
used simultaneously
%1 = Channel number
%2 = Block number, label
Compressor types COMPCURV and COMPCAD cannot be used in combination with tool
radius compensation. Only compressor type COMPON can be activated while tool radius
compensation is active.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 maximum cubic polynomials are allowed on active radius
compensation.
%1 = Channel number
%2 = Block number, label
With active radius compensation, only up to cubic polynomials are permissible for the
geometry axes. In this case no 4th or 5th degree polynomials can be programmed.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 function %3 not possible with path correction
%1 = Channel number
%2 = Block number, label
%3 = Function name
With this software release, the specified function can not yet be used together with tool
radius compensation. Please modify the part program or obtain a higher software
version.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02