Siemens SINUMERIK 840D Series Diagnostics Manual page 383

11.02
Reactions:
Remedy:
Program Continuation:
61116
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61117
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61118
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61119
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check parameter _AS1 or _AS2.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 approach or retraction path = 0
%1 = Channel number
%2 = Block number, label
The approach or retract path has been specified with zero. Alarm triggered by following
cycle: CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check parameter _LP1 or _LP2.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 active tool radius <= 0
%1 = Channel number
%2 = Block number, label
The radius of the active tool is negative or zero. Alarm triggered by following cycles:
CYCLE71, POCKET3, POCKET4.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify radius.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 length or width = 0
%1 = Channel number
%2 = Block number, label
The length or width of the milling area is illegal. Alarm triggered by following cycle:
CYCLE71.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Check parameters _LENG and _WID.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 nominal or core diameter incorrectly programmed
%1 = Channel number
%2 = Block number, label
The nominal or core diameter was incorrectly programmed. Alarm triggered by following
cycles: CYCLE70, E_MI_TR, F_MI_TR.
1 Alarms
1-383