Siemens SINUMERIK 840D Series Diagnostics Manual page 432

1 Alarms
103010
Definitions:
Reactions:
Remedy:
Program Continuation:
103011
Definitions:
Reactions:
Remedy:
Program Continuation:
103014
Definitions:
Reactions:
Remedy:
Program Continuation:
104000
Definitions:
Reactions:
Remedy:
Program Continuation:
104001
Definitions:
Reactions:
Remedy:
Program Continuation:
104002
Definitions:
Reactions:
Remedy:
Program Continuation:
1-432
Invalid file name
The file name entered:
• Must not have more than 32 characters (letters, digits, underscore; including the block
and program ID:_N_ and _MPF), amounts to 25 assignable characters.
• Cannot have any separators (e.g. /).
• Must have letters at the first and second position.
- -
-
Internal
No program selected - block search finished
At the moment, no program is selected, therefore, no search run is possible.
- -
Select a program.
Internal
Please reference the axis first
The reference point approach was not yet performed or finished.
- -
Perform reference point approach.
Internal
Current tool not found
If the cursor in the window "Magazine list" is at a blank line, then no tool will be found after
pressing the soft key "Tool data".
- -
Place the cursor on the tool.
Internal
No other tools available
After pressing the soft key "T No. +" or "T No. -" the next-highest or next-lowest tool num-
ber is searched for.
If no other tools are available, this message will be output.
- -
-
Internal
No other cutting edges available
After pressing the soft key "D No. +" or "D No. -" the next-highest or next-lowest cutting
edge is searched for.
If no other cutting edges are available, this message will be output.
- -
-
Internal
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02