List Of Action Numbers - Siemens SINUMERIK 840D Series Diagnostics Manual

11.02
1.3
No. 1
Explanation
Not allowed if
Remedy
No. 2
Explanation
Not allowed if
Remedy
No. 3
Explanation
Not allowed if
Remedy
No. 4
Explanation
Not allowed if
Remedy
No. 5
Explanation
Not allowed if
Remedy
No. 6
Explanation
Not allowed if
Remedy
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition

List of action numbers

The following list describes the actions stated in the alarm texts under "Action %.."
according to their numbers.
Run Init phase (tasks are initialized after Power On)
-
-
Perform Reset (VDI signal: Reset, mode group Reset or after Power On)
-
-
Activate Reset Init blocks (VDI signal: Reset)
-
-
Perform Reset, end of program has been detected (NC block with M30)
-
-
Change the mode to the MDA or AUTOMATIC program operating mode
(VDI signal: mode group)
1. The channel is active (program running, block search, loading machine data)
2. The other program operating mode has already been started.
3. A channel has exited the mode group due to an interrupt.
4. Overstore or digitizing has been selected.
> Abort the program (Reset key) or stop the program (not with block search, loading MD)
> Abort the program (Reset key)
> Abort the program with the Reset key or wait until the interrupt is terminated.
> Deactivate overstore, digitizing
Automatic change from an internal mode to the mode that was externally set (with
TEACH_IN an attempt is made after every stop to change from the internal mode "AUTO-
MATIC, MDA" to TEACH_IN)
-
-
1 Alarms
1-575