Siemens SINUMERIK 840D Series Diagnostics Manual page 455

11.02
Remedy:
Program Continuation:
112329
Definitions:
Reactions:
Remedy:
Program Continuation:
112330
Definitions:
Reactions:
Remedy:
Program Continuation:
112350
Definitions:
Reactions:
Remedy:
Program Continuation:
112360
Definitions:
Reactions:
Remedy:
Program Continuation:
112400
Definitions:
Reactions:
Remedy:
Program Continuation:
112401
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Machining can be continued with the specified values, but it will not correspond exactly to
the programming.
Internal
Set swivel head/table
The operator is prompted to set the swivel head/table in accordance with the specified
data.
- Alarm display.
Set swivel head/table.
When doing this, please follow the machine manufacturer's instructions.
Internal
Set swivel table.
The operator is prompted to set the swivel table in accordance with the specified data.
- Alarm display.
Set swivel table.
When doing this, please follow the machine manufacturer's instructions.
Internal
No swivel data set up.
There are no swivel data blocks.
- Alarm display.
Set up swivel data blocks (see /FBSP/, ShopMill Description of Functions)
Internal
The step was not accepted into the program sequence, as the program is running.
The program that you want to change is being executed in the operating mode "Machine
auto". You can only change programs that are not being executed in the operating mode
"Machine auto".
- Alarm display.
Stop the program run in the "Machine auto" operating mode.
Internal
Is not available in the tool management
The tool specified in the program does not exist.
- Alarm display.
The tool must be created before the data is saved.
Internal
Tool could not be created
When reading in the tool data, a tool could not be created.
- Alarm display.
Check tool management.
Internal
1 Alarms
1-455