Siemens SINUMERIK 840D Series Diagnostics Manual page 267

11.02
Reactions:
Remedy:
Program Continuation:
17605
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17610
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17620
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Example:
Machine axis A should be set to the new actual value A 100 at the absolute position A
300.
:
N100 G90 G00 A=300
N101 PRESETON A=100
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Avoid preset actual value memory for axes which are participating in a transformation or
deselect the transformation with the keyword TRAFOOF.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 transformation active: inhibits rotation of axis con-
tainer
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The programmed axis/spindle is active in a transformation and the axis container cannot
be rotated for this reason.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program. Deactivate the transformation for this axis/spindle before rotating the
axis container or perform the axis container rotation later.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 involved in the transformation, action cannot be car-
ried out
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
The axis is involved in the active transformation. It can therefore not execute the
demanded action, traversing as positioning axis, enable for axis replacement.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Deselect the transformation with TRAFOOF ahead of time or remove the action from the
part program block
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 approaching fixed point for transformed axis %3 not possible
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
In the displayed block, an axis is programmed for the fixed point approach (G75) that is
involved in the active transformation. Fixed point approach is not performed with this axis!
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
1 Alarms
1-267