Siemens SINUMERIK 840D Series Diagnostics Manual page 226

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
16510
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16700
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16710
Parameters:
Definitions:
1-226
A negative chamfer or rounding has been programmed under the keywords CHF= ...,
RND=... or RNDM=...
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Values for chamfers, roundings and modal roundings must be programmed with positive
values only.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 no facing axis available
%1 = Channel number
%2 = Block number, label
Diameter programming has been activated with the keyword DIAMON although no facing
axis has been programmed in this NC block.
If the diameter axis is not a geometry axis, in the initial setting "DIAMON" the alarm
appears as soon as the control is switched on.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department. Activate the modal G func-
tion DIAMON only in NC blocks containing a facing axis or deactivate diameter program
with DIAMOF.
In machine data 20150 GCODE_RESET_VALUES[28] select "DIAMOF" for the initial set-
ting.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 invalid feed type
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
In a thread cutting function, the feed has been programmed in a unit that is impermissible.
1. G33 (thread with constant lead) and the feed have not been programmed with G94 or
G95.
2. G33 (thread with constant lead) is active (modal) and G63 is programmed additionally
in a following block .conflict situation! (G63 is in the 2nd G group, G33, G331 and G332
are in the 1st G group).
3. G331 or G332 (rigid tapping) and the feed have not been programmed with G94.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Use only the feed type G94 or G95 in the thread cutting functions.
After G33 and before G63, deselect the thread cutting function with G01.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 master spindle not programmed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A master spindle function has been programmed (G33, G331, G95, G96) but the speed or
the direction of rotation of the master spindle is missing.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02